Table of Contents
Advertisement
Appendix
Offset Specification and Logical Page Size Explained
The two sets of numerical values that make up the Offset Specification and the Logical Page
Size are dependent on two variables:
1. The DPI (dots per inch) selected in the imposition file, which can be either:
•
300x300 DPI or;
•
600x600 DPI
2. The width of the logical page (image area) being printed.
Note
In the following paragraph, it mentions that a logical page size of 5.6 in (142 mm) by 12 in
(305 mm) is used. This is because 5.6 in (142 mm) by 12 in (305 mm) is the size of the test
pattern printed to perform color calibration using the Xerox 490/980 Color Continuous Feed
Printing System SIR.
Later in this chapter, there is a
shows the numerical values for the Offset Specification and Logical Page Size for widths of
paper stock from 8.3 (211 mm) in to 19.5 in (495 mm) and a logical page size of 5.6 in (142
mm) by 12 in (305 mm).
If the width of the paper stock you are using is not covered in the
, use the sample procedure in the section
Logical Page Size Values
to determine the appropriate numerical values.
Logical Page Size Values
A-2
Xerox 490/980 Color Continuous Feed Printing System
Table of Offset Specification and Logical Page Size Values
. This table
Table of Offset Specification and
Calculate Offset Specification and
Printer Operator Guide
Advertisement
Table of Contents
