Chapter 5 Appendix; Configuring Sata Hard Drive(S); Configuring The Onboard Sata Controller - Gigabyte GA-MA790GP-DS4H User Manual

Chapter 5 Appendix

5-1

Configuring SATA Hard Drive(s)

To configure SATA hard drive(s), follow the steps below:
A. Install SATA hard drive(s) in your computer .
B. Configure SATA controller mode in BIOS Setup.
C . Configure a RAID array in RAID BIOS.
D. Make a floppy disk containing the SA TA RAID/AHCI driver.
E. Install the SATA RAID/AHCI driver and operating system.
Before you begin
Please prepare:
• At least two SATA hard drives (to ensure optimal performance, it is recommended that you use
two hard drives with identical model and capacity). If you do not want to create RAID, you may
prepare only one hard drive.
• An empty formatted floppy disk.
• Windows Vista/XP setup disk.
• Motherboard driver disk.

5-1-1 Configuring the Onboard SATA Controller

A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available
SATA port on the motherboard. Then connect the power connector from your power supply to the hard
drive.
(Note 1) Skip this step if you do not want to create RAID array on the SA TA controller.
(Note 2) Required when the SATA controller is set to AHCI or RAID mode.
(Note 3) To install W indows Vista onto your SATA RAID drives, please go to GIGABYTE's website to
download the W indows Vista SATA RAID driver.
(Note 1)
(Note 3)
- 75 -
(Note 2)
(Note 2)
Appendix