Gigabyte GA-MA78GPM-UD2H User Manual page 76

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup .
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).
Ensure OnChip SATA Controller is enabled under Integrated Peripherals. To enable RAID for the
SATA2_0/1/2/3 connectors, set OnChip SATA Type to RAID. To enable RAID for the SATA2_4/ESATA
connectors, set OnChip SATA Type to RAID and set OnChip SATA Port4/5 Type to As SATA Type
(Figure 1).
OnChip IDE Channel
OnChip SATA Controller
OnChip SATA Type
OnChip SATA Port4/5 Type
Onboard Audio Function
Onboard 1394 Function
Onboard LAN Function
 SMART LAN
Onboard LAN Boot ROM
OnChip USB Controller
USB EHCI Controller
USB Keyboard Support
USB Mouse Support
Legacy USB storage detect
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
: Move
Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
GA-MA78GPM-UD2H Motherboard
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Integrated Peripherals
+/-/PU/PD: Value
F6: Fail-Safe Defaults
[Enabled]
[Enabled]
[RAID]
[As SATA Type]
[Enabled]
[Enabled]
[Enabled]
[Press Enter]
[Disabled]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Enabled]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
3
F10: Save
Figure 1
- 76 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults