Hard Disk Boot Priority; Password Check - Gigabyte GA-MA785GMT-UD2H User Manual

Onboard VGA output connect
Specifies the graphics display of the onboard VGA output from the D-SUB/DVI-D or D-SUB/HDMI.
Auto
D-SUB/DVI
D-SUB/HDMI
AMD C1E Support
Enables or disables the C1E CPU power-saving function in system halt state. When enabled, the CPU
core frequency and voltage will be reduced during system halt state to decrease power consumption.
(Default: Disabled)
Virtualization
Virtualization allows a platform to run multiple operating systems and applications in independent parti-
tions. With virtualization, one computer system can function as multiple virtual systems.
(Default: Disabled)
Patch AMD TLB Erratum
Enables or disables the Patch AMD TLB Erratum function. (Default: Enabled)
AMD K8 Cool&Quiet control
Auto
Disabled

Hard Disk Boot Priority

Specifies the sequence of loading the operating system from the installed hard drives. Use the up or
down arrow key to select a hard drive, then press the plus key <+> (or <PageUp>) or the minus key <-> (or
<PageDown>) to move it up or down on the list. Press <Esc> to exit this menu when finished.
First/Second/Third Boot Device
Specifies the boot order from the available devices. Use the up or down arrow key to select a device
and press <Enter> to accept. Options are: Floppy, LS120, Hard Disk, CDROM, ZIP, USB-FDD, USB-ZIP,
USB-CDROM, USB-HDD, Legacy LAN, Disabled.

Password Check

Specifies whether a password is required every time the system boots, or only when you enter BIOS
Setup. After configuring this item, set the password(s) under the Set Supervisor/User Password item in
the BIOS Main Menu.
Setup
System
HDD S.M.A.R.T. Capability
Enables or disables the S.M.A.R.T. (Self Monitoring and Reporting Technology) capability of your hard
drive. This feature allows your system to report read/write errors of the hard drive and to issue warnings
when a third party hardware monitor utility is installed. (Default: Enabled)
(Note) This item appears only if you install a CPU that supports this feature.
BIOS Setup
Lets the BIOS automatically determines the primary display port for output,
depending on to which port the display device is connected, D-SUB/DVI-D or
D-SUB/HDMI. (Default)
Sets the D-SUB/DVI-D as the graphics display.
Sets the D-SUB/HDMI as the graphics display.
(Note)
(Note)
Lets the AMD Cool'n'Quiet driver dynamically adjust the CPU clock and VID to
reduce heat output from your computer and its power consumption. (Default)
Disables this function.
A password is only required for entering the BIOS Setup program. (Default)
A password is required for booting the system and for entering the BIOS Setup
program.
- 48 -