Appendix A: Miscellaneous Notes - Epson TM-T88III Series Specification

Confidential

APPENDIX A: MISCELLANEOUS NOTES

A.1 Notes on Printing and Paper Feeding
1) Because the TM-T88III series printer is a line printer, it automatically feeds paper after printing the
data.
Therefore, when the line spacing for one line is set to a smaller value than the print data, paper
may be fed more than the set amount just to print the data.
For example, when the line spacing for one line is set to 10 dots (10/180 inches) and only paper
feeding is executed, paper is fed for 10 dots; however, if bit-image characters are printed, paper is
fed for 24 dots. (Refer to Table A.1.)
When only rotated characters are printed on one line, paper feeding is executed as shown in
Table A.1.
Normal Characters
Rotated Characters
Bit image (ESC )
2) When the printer goes to the standby (data-waiting) state during printing, it temporarily stops
printing and feeding paper. When data is transmitted and printing is executed, paper may shift 1
to 3 dots from the print starting position, which especially affects bit-image printing.
3) Interval of autocutting operation in the receipt section
For driving the auto cutter of the receipt section, take the interval as a minimum of 10 lines of
printing or paper feeding (to prevent small pieces of cut paper from dropping into the auto cutter).
EPSON
Table A.1 Paper Feeding Amount
Required Paper Feeding Amount (dots)
Font A
24
Font B
17
Kanji font
24
Font A
12
Font B
9
Kanji font
24
24
TITLE
TM-T88III series
Specification
(STANDARD)
number of times enlarged in vertical
number of times enlarged in vertical
number of times enlarged in vertical
number of times enlarged in vertical
number of times enlarged in vertical
number of times enlarged in vertical
SHEET
REVISION
B
NO.
NEXT SHEET
App.2 App.1