Table of Contents
Advertisement
Corrosion and dirt on the battery and
terminals can cause the battery to "leak"
power.
• Open battery box door.
• Disconnect
BLACK battery cable first
then RED
battery cable and remove
battery from tractor.
• Rinse the battery with plain water and
dry.
• Clean terminals and battery cable ends
with wire brush unt{I bright.
• Coat terminals with grease or petro-
leum jelly.
• Reinstall battery (See "REPLACING
BATTERY"
in the SERVICE AND
ADJUSTMENTS
section of this
manual).
V-BELTS
Check V-belts for deterioration
and wear
after 100 hours of operation and replace if
necessary. The belts are not adjustable. Re-
place belts if they begin to slip from wear.
TRANSAXLE
COOLING
The transmission fan and cooling fins should
be kept clean to assure proper cooling.
Do not attempt to clean fan or transmission
while engine is running or while the trans-
mission is hot. To prevent possible damage
to seals, do not use high pressure water or
steam to clean transaxle.
• Inspect cooling fan to be sure fan blades
are intact and clean.
• Inspect cooling fins for dirt, grass clippings
and other materials.
To prevent damage
to seals, do not use compressed air or high
pressure sprayer to clean cooling fins.
TRANSAXLE
PUMP FLUID
The transaxle was sealed at the factory and
fluid maintenance is not required for the life
of the transaxle.
Should the transaxle ever
leak or require servicing, contact your near-
est authorized service center/department
ENGINE
LUBRICATION
Only use high quality detergent oil rated
with API service classification SF, SG, or
SH. Select the oil's SAE viscosity grade
according
to your expected
operating
temperature.
SAE VISCOSITY GRADES
NOTE:
Although multi-viscosity
oils
(5W30, 10W30 etc.) improve starting in
cold weather, these multi-viscosity
oils will
result in increased oil consumption
when
used above 32°F. Check your engine oil
level more frequently to avoid possible
engine damage from running low on oil.
Change the oil after every 50 hours of
operation or at least once a year if the
tractor is not used for 50 hours in one year
Check the crankcase oil level before
starting the engine and after each eight (8)
hours of operation. Tighten oil fill cap/
dipstick securely each time you check the
oil level.
TO CHANGE ENGINE OiL
Determine temperature
range expected
before oil change.
All oil must meet API
service classification SF, SG or SH.
• Be sure tractor is on level surface.
• Oil will drain more freely when warm.
• Catch oil in a suitable container.
• Remove oil fill cap/dipstick.
Be careful
not to allow dirt to enter the engine
when changing oil.
• Remove drain plug.
• After oil has drained completely,
replace
oil drain plug and tighten securely.
• Refill engine with oil through oil fill
dipstick tube.
Pour slowly.
Do not
overfill.
For approximate
capacity see
"PRODUCT SPECIFICATIONS"
section
of this manual.
• Use gauge on oil fill cap/dipstick
for
checking level. Be sure dipstick cap is
tightened securely for accurate reading.
Keep oil at "FULL" line on dipstick.
Air Screen__
_
Oil Drain
Oil Fill Cap/__.._
ug
Dipstsick
_
CLEAN
AIR SCREEN
Air screen must be kept free of dirt and
chaff to prevent engine damage from
overheating.
Clean with a wire brush or
compressed air to remove dirt and
stubborn dried gum fibers.
2O
Hide quick links:
Advertisement
Table of Contents
