Kickback Safety Features; Chain Brake - Craftsman 358.360360 Instruction Manual

• Position your l eft h and o nthe front
handlebar soitisinastraight line
with your r ight hand o nthe rear
handle when m aking bucking cuts.
Never reverse right and lefthand
positions forany type ofcutting.
• Stand w ith your weight evenly bal-
anced o nboth feet.
• Donot o verreach. You could b e
drawn o rthrown off b alance and lose
control ofthe saw.
• Donot c ut a bove s houlder height. It
isdifficult tomaintain control ofsaw
above s houlder height.
KICKBACK
SAFETY FEATURES
WARNING: Tile following fea-
tures are included on your saw to help
reduce the hazard of kickback; however,
such features will not totally eliminate
this danger. Do not rely only on safety
devices. Follow all safety rules to help
avoid kickback and other forces which
can result in serious injury.
• Front Hand Guard, designed to reduce
the chance of your left hand contact-
ing the chain if your hand slips off the
front handlebar.
• Position of front and rear handlebars,
designed with distance between han-
dles and "in-line" with each other. The
spread and "in-line" position of the
hands provided by this design work
together to give balance and resis-
tance in controlling the pivot of the
saw back toward the operator if kick-
back occurs.
• Reduced-Kickback Guide Bar, de-
signed with a small radius tip which
reduces the size of the kickback
danger zone on the bar tip. This type
of bar has been demonstrated to sig-
nificantly reduce the number and se-
riousness of kickbacks when tested
in accordance with ANSI B175.1.
_ Smali Radius
Tip Guide Bar
Large Radius {_
Tip Guide Bar
• Low-Kickback Chain, has met kick-
back performance requirements
when tested on a representative
sample of chain saws below 3.8 cu-
bic inch displacement specified in
ANS! B175.1.
Low-Kickback Chain
Contoured Depth Gauge
_.,,_ longated Guard Link
deflects kickback
force And allows
wood to gradually
ride into Cutter
CHAIN BRAKE
• Chain Brake, designed to stop tile
chain in the event of kickback.
,I_WARNING: WE DO NOT REP-
RESENT AND YOU SHOULD NOT AS-
SUME THAT THE CHAIN BRAKE WILL
PROTECT YOU IN THE EVENT OF A KICK-
BACK. Kickback is a lightning fast action
which throws the bar and rotating chain
back and up toward the operator. Kick-
back can be caused by allowing contact
of the bar tip in the danger zone with
any hard object. Kickback can also be
caused by pinching the saw chain along
the top of the guide bar. This action may
push the guide bar rapidly back toward
the operator. Either of these events may
cause you to lose control of the saw
which could result in serious injury or
even death. DO NOT RELY UPON ANY OF
THE DEVICES BUILT INTO YOUR SAW.
YOU SHOULD USE THE SAW PROPERLY
AND CAREFULLY TO AVOID KICKBACK.
Reduced-kickback guide bars and low-
kickback saw chains reduce the chance
and magnitude of kickback and are rec-
ommended. Your saw has a low kick-
back chain and bar as original equip-
ment. Repairs on a chain brake should
be made by an authorized Sears Ser-
vice Center. Take your unit to the place
of purchase if purchased from a servic-
ing dealer, or to your nearest Sears Ser-
vice Center
• Tip contact in some cases may cause
a lightning fast reverse REACTION,
kicking guide bar up and back toward
operator.
• Pinching the saw chain along the top
of the guide bar may push the guide
bar rapidly back toward the operator.
• Either of these reactions may cause
you to lose control of the saw which
could result in serious injury. Do not
rely exclusively upon devices built into
your saw.