Table of Contents
Advertisement
Setup
Battery Installation
•
On the back of the remote, push
down on the tab and lift the cover off.
•
Match the batteries to the + and -
marks inside the battery case, then
insert 3 AA Alkaline batteries. Make
sure you use new batteries. You can
have problems with learning codes if
your batteries are old.
•
Press the battery cover back into
place.
Battery Saver
Your remote automatically turns off if the keys are depressed
for more than 30 seconds. This will save your batteries should
your remote get stuck in a place where the keys remain
depressed (e.g., between the sofa cushions). Also, the screen
turns off a short time after no keys have been pressed for a
while (or a short time after a key has been stuck for 30
seconds). The duration before the screen turns off can be
adjusted from about 2 seconds to about 120 seconds from the
Setup, Advanced, and Options menu (see page 43).
Permanent Memory
All the devices you set up, their codes, punchthrough settings,
and all your favorites, etc., are stored in permanent memory
while you are changing batteries so you will not lose any codes
or settings stored in the remote while you are changing
batteries.
After you insert the batteries you'll see a screen asking you to
choose your language (English, Spanish, or French (Canadian).
Let's assume you choose English; proceed to page 9.
8
Using the Wizard
After you insert the batteries and choose
"English" the Setup Wizard screen (1)
appears. You can exit the Wizard at any
time by pressing the HOME key (located
just below the screen). Press any key at
screen (1) to continue and follow the
instructions on the screens.
Pressing OK at screen (2) takes you to the
next screen (3). Pressing the Left
navigation key (Back key) on the remote
at screen (3) takes you to screen (4) that
has 10 yellow arrows. This is an
exception to the rule because we're
teaching you how to use the remote. But
pressing Back again at this point does
take you "back."
Try pressing the Back key a few times to
go back through the Wizard and then
follow the instructions on the screens
again to familiarize yourself with how to
step through the screens and go back. You
can go back and forth through the Wizard
but once you've set up your devices and
quit to save the settings, you won't see the
Wizard again unless you do a Master
Reset.
To do a Master Reset: Press the HOME
key, Setup, More, Advanced, Clear
Settings, More, and then Master Clear.
Note: This will erase everything you have
set up in the remote.
Pressing any of the 10 Side
Keys (K1 thru K10) at screen
(4) takes you to the screen
where you set up your first
device (TV). See next page.
(1)
(2)
(3)
(4)
K1
K6
K2
K7
K3
K8
K4
K9
K5
K10
9
Advertisement
Table of Contents
