X10 IconRemote IR32A Owner's Manual page 2

SAFETY CONSIDERATIONS
Remember to exercise good common sense
when using the Home Automation features of
your remote - especially when scheduling
unattended devices. There can be some
unexpected consequences if not used with
care. For example, an empty coffee pot can be
remotely turned on. If that should happen,
your coffee pot could be damaged from
overheating. If an electric heater is turned on
by remote control while clothing is draped
over it, a fire could result.
DO NOT USE the remote for the control of
high power heating appliances such as
portable heaters.
Caution: To reduce the risk of electric shock, do
not disassemble any part of the Home
Automation System's plug-in Modules or
Controllers. No user serviceable parts are inside.
If you spill liquid on a unit, disconnect the unit
from the AC outlet to prevent possible fire or
shock hazard and consult authorized service
personnel. Powerline operated equipment or
accessories connected to any of these units
should bear the UL listing or CSA certification
mark and should not have been modified in any
way that might defeat their safety features.
Warning: To prevent electric shock hazard, do
not expose any part of the Home Automation
System to rain or moisture.
2
FCC Caution
THIS DEVICE COMPLIES WITH PART 15 OF THE
FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
This equipment generates and uses radio frequency
energy, and if not installed and used properly, that is, in
strict accordance with the manufacturers instructions, it
may cause interference to radio and television
reception. It has been type tested and found to comply
with the limits for remote control devices in accordance
with the specifications in Sub-Parts B and C of Part 15
of FCC Rules, which are designed to provide reasonable
protection against such interference in a residential
installation. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause interference to radio or
television reception, which can be determined by
unplugging the equipment, try to correct the interference
by one or more of the following measures:
• Reorient the antenna of the radio/TV experiencing the
interference.
• Relocate the interface with respect to the radio/TV.
• Move the interface away from the radio/TV.
• Plug the interface into an outlet on a different
electrical circuit from the radio/TV experiencing the
interference.
• If necessary, consult your local Dealer for additional
suggestions.
NOTE: Modifications to any of the components in this
kit will void the user's authority to operate this
equipment.
3