Summary of Contents for Wright Manufacturing Stander ZK 55138
Page 1
Commercial Mower Owner’s Manual For Stander ZK serial #55138 and higher until superseded WARNING: READ THIS MANUAL BEFORE USING Revised 7/2011 For your safety and for proper operation and maintenance read carefully and keep readily available for future reference. Additional replacement owner’s manuals as well as illustrated parts lists are available from your authorized Wright Dealer for a nominal charge.
Pre-Delivery Service of Mower by Dealer If you are not completely familiar with the Safety Instruction Manual read it now before proceeding with the Pre-Delivery Service of the mower. Only your authorized Wright dealer should perform the Pre- WARNING Delivery Service of the mower. The Wright Stander ZK is shipped completely assembled and has been adjusted and tested at the factory.
Page 5
• Before testing the blade clutch/brake operation, make sure the area is clear and there is nothing vulnerable to possible thrown objects from under the mower. No one should be near the mower deck or in its line of discharge at this or at any time. The discharge chute deflector should be in the down position. •...
WARNING CAUTION This symbol with the word “CAUTION” indicates a This symbol with the word “WARNING” indicates a potentially hazardous situation which, if not potentially hazardous situation which, if not avoided, could result in minor or moderate injury. avoided, could result in death or serious injury. SAFETY INSTRUCTION MANUAL TO WRIGHT MOWER USERS &...
equipment is in safe working condition. Check the blade mounting bolts for proper tightness WARNING every eight (8) hours of operation. Check the blades for excessive wear and sharpness every four to eight (4-8) hours of operation. Replace User Clothing: excessively worn blades.
• Before attempting to start the engine, follow all • Be alert for traffic when crossing roads or starting instructions below and in the operating near roadways. • Before climbing curbs, crossing gravel drives, engine operator’s manual. • Look behind before backing up. sidewalks or roads, turn off the blades, lift •...
weight on the higher side drive wheel, tending to make it slip. This is the preferred angle for WARNING mowing large areas of gentle slopes. Operation on Slopes Recommendations for this angle: DO NOT operate on steep slopes. Do not •...
WARNING Replacement Parts Use of parts other than specified parts supplied by Wright Manufacturing, Inc. may compromise the safe use of the mower, are not recommended and their use could void the warranty. Always check with your Dealer or the Wright Mfg website for the latest Illustrated Parts List for your equipment.
OPERATING INSTRUCTIONS If you are not completely familiar with the Safety Instruction Manual read it now before proceeding with the operation of the mower. REMEMBER THERE ARE CERTAIN PRECAUTIONS WARNING LISTED IN THIS MANUAL THAT YOU MUST NOW TAKE BEFORE STARTING THE MOWER. Starting the engine Inspect Mower Before Each Use Electric Start:...
How to Stop and Park the Mower curb and you will be able to more safely control the mower. Come to a complete stop. If the blades are on, turn them off using the switch on the instrument How to Use the Mower on Varying Terrain panel.
are the slower, less sensitive setting. You must then torsion rods are level, proceed to the upper control perform the Tracking Adjustment described below. rods connected to the control levers. Loosen the jam nuts on both ends of the upper How to Perform the Tracking Adjustment control rod.
both feet firmly on the foot platform and turn on the hold the deck. Adjust the rear deck hangers (by blade clutch switch. Run blades for a minute or so. using a socket through the hole above the toe Try engaging and disengaging the blades a few area of the platform) to achieve a ¼...
cooler hoses so they do not snap pump fans. The debris screen should be removed before blowing Vent / cooler out from the bottom. When reinstalling the Purge cooler, make sure the cooler hoses do not interfere with the fans and ensure the cooler housing is secure Tank under the four tab points of the cooler bracket.
WRIGHT MANUFACTURING, INC. POWER EQUIPMENT LIMITED WARRANTY THIS WARRANTY SUPERSEDES ALL PREVIOUS ON UNITS WITH A RETAIL SALES DATE ON OR AFTER 04/01/05 Wright Manufacturing, Inc. (hereinafter: WMI) warrants to the original The WMI mower, including any defective part, must be returned to an owner that the new WMI mower accompanying this document will be Authorized WMI Service Dealer within the warranty period.
Page 20
FEDERAL AND CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The United States Environmental Protection Agency (EPA), California Air Resources Board (CARB) and Wright Manufacturing, Inc. (WMI) are pleased to explain the evaporative emission control system (EECS) warranty on your 2011 commercial mower.
Page 21
(4) Repair or replacement of any warranted part under the warranty provisions herein must be performed at a warranty station at no charge to the owner. (5) Notwithstanding the provisions herein, warranty services or repairs will be provided at all of our distribution centers that are franchised to service the subject engines or equipment.