Installing The New Cartridge - Epson Stylus Color 850N Quick Manual

The print heads move slightly left and the
begins flashing. (The print heads return to their home
position if you don't proceed to step 4 within 60 seconds.)
Caution:
To avoid damaging the printer, never move the print heads by hand.
4. Pull up the ink cartridge clamp. The cartridge rises up from
its holder. (Although the illustration shows the black ink
cartridge, the procedure is the same for replacing the color
ink cartridge.)
Caution:
Don't open the clamp or remove a cartridge except to replace it
with a new one. Once you remove a cartridge, you can't reuse it,
even if it contains ink.
5. Lift the cartridge out of the printer and dispose of it
carefully.
Warning:
If ink gets on your hands, wash them thoroughly with soap and
water. If ink gets into your eyes, flush them immediately with
water.
6. Follow the steps in the next section to install the new ink
cartridge.

Installing the New Cartridge

Once you have removed the empty cartridge, you're ready to
install the new one. Follow these steps:
1. Remove the new ink cartridge from its packaging.
2. Remove only the yellow part of the tape seal on top as
shown below. Don't pull off the white portion or try to
remove the clear seal underneath the cartridge.
P power light
Caution:
You must remove the yellow tape from the top of the cartridge or
you will permanently damage it. It's OK if the tape does not tear off
completely along its dotted line. Do not remove the clear seal from
the bottom of the cartridge; ink will leak out.
3. Lower the ink cartridge into its holder with the label facing
4. Press down the ink cartridge clamp until it locks in place.
5. If you need to replace the other ink cartridge, follow the
6. Press the
Caution:
Never turn off the printer when the
unless the printer hasn't moved or made any noise for more than
10 minutes.
4/98
EPSON Stylus COLOR 850N
Remove the yellow
tape seal, but
don't remove the
white portion
black cartridge
up and the arrow pointing to the back of the printer.
steps under "Removing an Empty Ink Cartridge," and then
steps 1 through 4 under "Installing the New Cartridge."
load/eject button and close the printer cover.
E
The printer moves the print heads and begins charging the
ink delivery system. (Even if you don't press the button, ink
charging begins 60 seconds after you close the clamp.)
The power light flashes, and the printer makes various
P
sounds. Charging takes about three minutes. When it's
finished, you can print again.
EPSON Stylus COLOR 850N
color cartridge
P power light is flashing,
- 9