Gigabyte GA-H61TN User Manual page 17

1) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status
indicator on the chassis to this header according to the pin assignments below. Note the positive and
negative pins before connecting the cables.
The front panel design may differ by chassis. A front panel module mainly consists of power switch,
reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis
front panel module to this header, make sure the wire assignments and the pin assignments are
matched correctly.
2) SATA0 (SATA 6Gb/s Connector) jk
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device.
SATA0 (SATA 3Gb/s Connector) l
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device.
j Only for GA-H77TN.
k Only for GA-B75TN.
l Only for GA-H61TN.
9
10
Pin No. Signal Name
1 HD+
2 MPD+
3 HD-
4 MPD-
5 GND
6 PW+
7 RST
8 PW-
9 WF_LED
SATA0
1 7
- 17 -
1
2
Definition
Hard Disk LED Signal anode (+)
Power LED Signal anode (+)
Hard Disk LED Signal cathode(-)
Power LED Signal cathode(-)
Ground
Power Button anode (+)
Reset Button
Power Button cathode(-)
Wifi active LED Signal
DEBUG
PORT
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND