Should your DVD player develop a problem, please check below before
requesting service:
Symptom
Check and Action
• Make
sure the unit has been powered
on manually.
No Power
• Check if the power cord has been properly connected to the power outlet.
• Checkifthe
Main Power switchon
the unit is turned
on.
Does not play
No Picture
Picture
noisy / distorted
Picture not full
screen
Problem
message
displayed
on screen
Malfunction
• No disc, load a disc.
• Disc has been loaded upside down. Place the disc with the label facing up.
• Disc's region code does not match to that of the player's.
• Disc's rating level is higher than the player's preset rating level.
• Disc is incorrect type for the player.
• Disc is damaged or dirty, Clean the disc or try another one.
• Moisture may be condensed inside the player, Remove the disc
and leave the unit power on for one or two hours,
• Check
if the TV set has been
powered
on.
Use'IV
remote
to select
AN
signal
for
DVD
rather than
broadcast.
• Check
if the system
connection
is properly
secured.
• Check
if the connection
cables
are damaged.
• Clean
the disc.
• Press OPEN
button
and
then
press
PROGRAM
and ZOOM
button
to
return
factory
default
status.
• The disc is dirty or damaged. Clean the disc or try another disc.
• Reset the color system of the TV set.
• Make sure the DVD is not connected
through
a VCR,Cabte
or Satellite
dish.
•
Select the screen format from the player's Set Up Menu,
see" Set Up Menu. "of this manual.
• Select the screen setup from DVD disc menu.
Following
messages
wilt be displayed
when there
is a problem
with the loaded disc:
• "WRONG
REGIONAL
DISC":
Disc's
region
code does
not match
to that of the player's.
• "WRONG
PASS
WORD":
The
player
may deny a disc with a rating
level
higher
than
the player's
preset
rating
level.
"WRONG
DISC"
: The player
is equipped
with automatic
disc
quality
detection
software.
When
the player
detects
a problem
or
damaged
disc,
the player
may keep playing
the disc at lower
quality
or
stop playing,
which will depend
on the damage
level of the disc.
•
Press and
hold the standby
button
(if any)
for about
5 seconds
to power
off.
•
Should
the player
develop
a malfunction,
unplug
the player
for
30 minutes.
After
30 minutes,
power
on the player
and the restore
function
should
reset the player.