Table of Contents
Advertisement
[_i_
• Unpack the unit,
_
• Read thigh
this owner, s manual before
installation and use.
,, Loading batteries in the remote control.
• Connect _
system; make sure the connections
are _re!
Loading batteries
in the remote control
• Remove the battery compartment
cover.
• Load two AAA (UM-4 or R03) batteries into the
battery compartment.
• Make sure that the batteries have been inserted
in the correct polarities matching to the symbols+,-
marked in the battery compartment. Close the
battery compartment cover.
• When replacing batteries,
replace both batteries.
Do not mix new and used batteries operating
together, otherwise,the
operation lifetime will be
much shorter than normal.
• Remove the batteries if the unit will not be used
for a prolonged
period of time.
2 x "AAA" 1.5Vbatteries
Switch on the player
Press the main power switch on the DVD player.
Power on the IV set, and the amplifier
is connected.
Set up the system
Select the corresponding
setting of the IV set
(AV1, AV2, S-Video, DVD etc ).
If connected to a RF modulator, select the
appropriate channel until the DVD screen
appears.
If amplifier
has been connected,
select the
corresponding
output mode.
Load a disc
Press OPEN button _
on the Front panel
to open the disc door.
Load a disc with label facing up and then close the
door by hand.
Automatic
playback
The unit will take a few seconds
to load the disc's
initial data, display the disc type logo on the left
upper corner on screen, and then start playing back
automatically.
I_r_F_
Normally ,when a MP3 disc is loaded, the player
will take longer time to load.
If a DVD disc menu appears on screen
Press PLAY button on the remote
(or on the unit) to start playing.
(_
Press the CURSOR buttons to select
(__
the desired feature in the menu.
And then press ENTER button to
(_
confirm.
Remote sensor
Within
6 meter (20 feet)
O
Advertisement
Table of Contents
