Connecting A Satellite Receiver With A Vcr - Sony KLV-23HR1 Operating Instructions Manual

Ir_stNI ng and Cor_r_ec_ingthe IV
Connecting a Satellite Receiver with a VCR
Disconnect all power sources before making any connections.
1
Connect the satellite antenna cable to the satellite receiver's SATELLITE
IN jack.
2 Connect the CATV cable to the VCR's VHF/UHF IN jack.
3 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV's VHF/UHF jack.
4 Using AUDIO and S VIDEO cables, connect the satellite receiver's
AUDIO and S V1DEO OUT jacks to the VCR's AUDIO and S V1DEO
IN jacks.
5 Using AUDIO and S VIDEO cables, connect the VCR's AUD10 and S
VIDEO OUT jacks to the TV's AUD10 and S V1DEO IN jacks.
Rear of TV
75-ohm
coaxial "
cable
(supplied)
AUDIO-R (red) .-o_ /
AUDIO-L (white) _
VIDEO (yellow) _--------
VMC-810S/820S _-
(not supplied)
Satellite J[ 4
antenna _ •
Satellite receiver cable
"-_ S VIDEO YC-15V/30V o
(not supplied)
VCR
VMC-
810S/820S
(not supplied)
4
YC-15V/30V
_- (not supplied)
3
75-ohm coaxial cable (supplied)
Note
To watch the pictures input from the S VIDEO input jack, set "Auto YC" to "On" in the _]_
(Setup) menu (See page 12).
Tips
• You can also use the VIDEO 2 IN jacks on the front panel of the TV to connect your VCR.
• Be sure your VCR's video input is set correctly. Consult your VCR's operating manual for
instructions.
• Use TV/VIDEO on the remote control to select VIDEO 1 IN (or VIDEO 2 IN if you use the
VIDEO 2 IN jacks for this hookup) to watch satellite TV or to watch a tape on the VCR
(your VCR must be turned on).
• If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.
14