Connecting A Satellite Receiver With A Vcr - Sony KLV-15SR1 Operating Instructions Manual

Ir_sta_l n g and Cor_r_eo_ingthe IV
Connecting a Satellite Receiver with a VCR
Disconnect all power sources before making any connections.
1
2
3
4
5
Connect the satellite antenna cable to the satellite receiver's SATELLITE
IN jack.
Connect the CATV cable to the VCR's VHF/UHF IN jack.
Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV's VHF/UHF jack.
Using AUDIO and S VIDEO cables, connect the satellite receiver's
AUDIO and S V1DEO OUT jacks to the VCR's AUDIO and S V1DEO
IN jacks.
Using AUDIO and S VIDEO cables, connect the VCR's AUD10 and S
VIDEO OUT jacks to the TV's AUD10 and S V1DEO IN jacks.
Rear of TV
75-ohm
coaxial
'_
cable
(supplied)
AUDIO-R (red) [_,_
AUDIO-L (white)
VIDEO (yellow) _------,,
VMC-810S/820S _---'
(not supplied)
-- S VIDEO YC-15V/30V
(not supplied)
Satellite J, ,4
Satellite receiver
aant,e2na _ 1
VHF_IJHF SAllL(nlE IN
I eg° 1
-_, YC-15V/30V
(not supplied)
3
VCR
75-ohm coaxial cable (supplied)
VMC-
810S/820S
(not supplied)
4
Note
To watch the pictures input fi'om the S VIDEO input jack, set "Auto YC" to "On" in the
(Setup) menu (See page 12).
Tips
• Be sure your VCR's video input is set correctly. Consult your VCR's operating manual for
instructions.
• Use TV/VIDEO on the remote control to select VIDEO 1 IN to watch satellite TV or to
watch a tape on the VCR (your VCR must be turned on).
• If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.
14