Installation; Unpacking; Gasket - Epson RC170 Manual

Epson rc170 printer operator panel

Hide thumbs Also See for RC170:

Table of Contents

3. Installation

OP1

Mounting metal hasp

Connection cable (3 m)

Bypass Plug (install on body)

3.2 Installation

Applicable model: ST400-WP01

Even in environment that do not require drip-proof, be sure to use the gasket (accessory

provided with OP1). Install the Operator Pendant on a flat, level surface with the display

facing down, and attach the gasket (provided) into the front bevelled groove from the rear.

For details on how to attach the gasket, refer to 6.5 About Gasket.

Precautions When Handling the Gasket

- Before you install the Operator Panel, make sure that the gasket is attached to the Operator

Panel.

Gasket that is used for long periods of time or once has been installed on the panel is

scratched or dirty, and may not qualify IP65 dust-proofing and drop-proofing performance.

Replace the gasket periodically or when obvious scratches or dirt is seen.

Do not insert the seams of the gasket at the corners of the Operator Panel. Inserting the

seams of the gasket at the corners of the Operator Panel may cause a tensile force to the

seams and the gasket may be torn.

To ensure stable dust-proof and drip-proof, attach the gasket so that its seams come to the

bottom side the product.

OP1 Rev.1a

1 unit

4 units

1 unit

Gasket

3. Installation

Table of Contents

Op1