To Use Your Printer With A Macintosh - Epson Stylus PRO 10000CF Startup Manual

To use your printer with a Macintosh

To use this printer, your Apple
following system requirements. You also need a USB cable to
connect this printer to Apple Macintosh computers.
Minimum system
PowerPC
System 7.6.1
11 MB of available memory
14 MB of available memory when
background printing is turned on.
-
*1 is for graphic data use
*2 is for line data use
Note:
The amount of available memory varies according to the number and
kind of applications that are open. To see how much memory is
available, choose About This Macintosh from the Apple menu and
refer to the memory size (listed in kilobytes) under "Largest Unused
Block" (1,024 K = 1 MB).
The memory requirements above are for printing on B0 (1030
1456 mm) size paper. These requirements may vary depending on
the size of the paper, the type of application you are using, and the
complexity of the document you want to print.
The available interface varies according to Macintosh system
version as follows.
Network interface: 7.6.1 to 9.x
USB interface: 8.1 to 9.x
IEEE 1394 interface: 8.6.x to 9.x
In addition to these system and memory requirements, you also
need 15 MB of free hard disk space to install your printer software.
iv
® ®
Macintosh must meet the
Recommended system
PowerPC G4 400 MHz or higher
processor
Mac OS 8.1 or later
33 MB or more of available memory
56 MB of available memory when
background printing is turned on.
1
500 MB* /300 MB*
disk space (B0)
2
or more free