Grizzly G0605X1 Owner's Manual page 26

7.
Fasten the support legs to the main extension
table with (8) m6-1 x 12 phillips head screws
and 6mm flat washers (see Figure 33).
Figure 33. support leg fastened to main
extension table.
8.
rotate both feet until they touch the ground,
and tighten the hex nuts against the legs to
secure the feet.
9.
Fasten the shelf end plate to the legs with (4)
m6-1 x 12 phillips head screws and 6mm flat
washers, as shown in Figure 34.
x4
Figure 34. installing shelf end plate on extension
table legs.
10. place the shelf brackets between the cabinet
and support legs, and fasten with (4) m6-1 x
12 hex bolts, (4) 6mm flat washers and (2)
m6-1 hex nuts, as shown in Figure 35.
Note: The flange on the shelf bracket must
point up to ensure proper installation.
11. place the lower shelf on the brackets.
-24-
x8
shelf Bracket
x2
Figure 35. shelf brackets installed.
G0605X1/G0606X1 Outfeed Table
1. turn the outfeed table upside down and
place it on a level surface.
2. install the feet, support legs, and shelf end
plate in the same manner as described in
Extension Table instructions on page 23.
3. place the extension table assembly upright
with the feet on the ground, align the slots in
the extension table bracket with the rear rail
mounting holes, then fasten the table to the
rail with (2) m8-1.25 x 16 flange bolts and
m8-1.25 hex nuts, as shown in Figure 36.
x2
Figure 36. outfeed table fastened to rear rail.
4. secure the lower shelf brackets to the sup-
port legs and cabinet with (4) m6-1 x 12 hex
bolts, (4) 6mm flat washers, and (2) m6-1 hex
nuts.
5. install the lower shelf on the brackets.
g0605X1-6X1, g0696X-97X (mfg. 8/11+)
Flange
x2
Bracket