Battery Replacement; Removing The Screws - Epson P-80 User Manual

Battery Replacement

Your P-80 uses a nickel cadmium battery. If the red light keeps flash-
ing after the battery has been charged, the battery has come to the end
of its life and must be replaced. Nickel cadmium batteries are available
through your Epson dealer.
To replace the battery, follow the steps below.
See that the power switch is OFF,
1.
Remove the two screws on the
2.
the printer by using a Phillips screwdriver (Figure
Carefully lift the battery holder cover by placing your index fingers
3.
at the top of the cover as shown in Figure
underneath the ridge at the bottom of the cover.
Figure

Removing the screws

2-4.
battery holder cover
2-4).
and your thumbs
2-5,
at the back of
19