Indicators - Epson MX-82 Operation Manual

When this switch is depressed once, the paper is advanced vertical-
FF SW:
ly to the next Top of Form position. This switch must be depressed
(Form Feed)
while the Printer is OFF-LINE. Otherwise, the form feed operation
will not be carried out.
The Top of Form position is initialized when the POWER switch is
turned on or when INIT signal is applied to the interface connector.
Therefore, before turning the POWER switch on to start operating
the Printer, set the paper at the appropriate Top of Form position.
LF SW:
The paper advances while this switch is being depressed.
The line spacing for paper advancement is determined by ESC A + n
(Line Feed)
code (described later). When the Power switch is turned on, the line
spacing is initialized at 1/6 inch.
The line feed operation is prohibited while the Printer is actively en-
gaged in printing.

1.2 Indicators

Illuminates while the Printer is receiving AC power.
POWER:
READY: Illuminates when the Printer is ready to receive data.
PAPER OUT:
Illuminates when the paper supply is near its end.
ON LINE: Illuminates when the Printer is in the ON-LINE mode.