Replacing A Secondary Node; Ethernet Switches - HP StorageWorks 12000 - Virtual Library System EVA Gateway User Manual

9. Reconfigure the node as described in
The warm failover feature will now automatically restore the original configuration and licenses.
The procedure is complete; you may omit the final step.
10. Restore the previously saved configuration. See

Replacing a Secondary Node

CAUTION:
Each VLS12000 node weighs 17.9 kg (39.5 lb) full. At least two people are required to lift and move
each node.
To replace a secondary node:
1. Remove the existing node from the rack:
a. Power off the system. See
b. From the back of the node, make a note of all cable connections then disconnect the cables.
c. From the front of the node, loosen the captive thumbscrews until the thumbscrews are free
of the rack.
d. Pull the node out from the rack until it stops.
e. Squeeze the release brackets (see
2. Install the new node into the rack. See
3. Reconnect the cables to the new node exactly as they were connected to the previous node.
4. Configure the node according to the instructions provided in
1 through
5. Reboot the system. See

Ethernet Switches

To replace the 100 Mb Ethernet Switch 2510 24 or the 1 Gb Ethernet Switch 2810 24G:
1. Power off the switch.
2. Make a note of all cable connections to the switch then disconnect the cables.
3. From the front of the switch, loosen the captive thumbscrews until the thumbscrews are free of
the rack.
4. Remove the switch from the rack.
5. Install the new switch into the rack. See
Rack or Installing the 1 Gb Ethernet Switch 2810-24G into a
NOTE:
If you are replacing a 2824 with a 2810-24G, you will need to install new rails. The
2810-24G cannot use the 2824 rails.
Powering Off the
7.
Rebooting the
Step 4.
Restoring the Configuration
System.
Figure 68), then pull the node free from the rails.
Installing the VLS Node into a
Configuring the Secondary Nodes
System.
Installing the 100 Mb Ethernet Switch 2510-24 into a
Rack.
Settings.
Rack.
HP StorageWorks 211