Changing The Default Settings - Epson LQ-670 User Manual

AGM (Alternate Graphics Mode)
When AGM is on, the printer can use advanced graphics
commands like those available in ESC/P 2 mode. This feature is
available only in IBM emulation mode. The default setting is Off.
Font
In the default-setting mode, you can select from these six fonts:
OCR-B, Orator, Orator-S, S cript C, Roman T, and S ans Serif H.
The following additional fonts are available only by pressing
the Font button on the control panel: Draft, Roman, Sans Serif,
Courier, Prestige, and Script. You cannot select the control
panel fonts in the default-setting mode.

Changing the default settings

Follow the steps below to enter the default-setting mode and
change the printer's default settings.
Note:
❏ To print the language selection sheet and the default-setting
mode instruction sheets, you need four sheets of A4 or letter
size single-sheet paper or 11-inch or longer continuous paper.
See Chapter 3, "Paper Handling," for instructions on loading
single-sheet and continuous paper.
❏ If you use single-sheet paper to print the default-setting mode
instruction sheets, be sure to load a new sheet of paper each time
the printer ejects a printed sheet. Otherwise, you cannot proceed
to the next step.
4-14
Using the Control Panel