Troubleshooting - Uniden XC 320 Operating Manual

Troubleshooting
If your XC 320 Cordless Telephone is not performing to your expectations,
please try these simple steps. If you are still unable to resolve the problems,
contact Uniden Customer Service for assistance.
Note: Do not attempt to service this unit yourself. All service must be done
by qualified service personnel.
22
Problem
Suggestion
Charge light won't come on
.
Make sure the AC Adapter is plugged into the
when Handset is placed in
Base Unit and wall outlet.
BaseUnit. .
Make sure Handset is properly seated in Base
Unit.
.
Make sure the Nickel-Cadmium Battery Pack is
plugged in inside the Handset.
. Check/Clean battery charge contacts (refer to
page 14).
Audio sounds weak and/or
. Make sure that the Base Unit antenna is fully
scratchy.
extended and vertical.
. Move the Handset and/or Base Unit to different
locations and try again.
.
Press the CHANNEL b utton to select another
channel.
Can't make or receive calls.
. Check both ends of the Base Unit telephone
line cord.
.
Make sure the AC Adapter is plugged into the
Base Unit and wall outlet.
.
Disconnect the AC Adapter for a few minutes,
and then reconnect it.
Handset doesn't ring or
. Nickel-Cadmium Battery Pack may be weak.
receive a page.
Charge the battery on the Base Unit for more
than 12 hours.
. Set the RING ON/BA T TSAVE switch on the
Handset to "RING ON".
.
Extend the Base Unit antenna vertically.
.
The Handset may be too far away from the
Base Unit.
.
Place the Base Unit away from noise sources.
. The Digital Security Code may be erased. Set
the Digital Code. (See page 6 for instructions.)
Base Unit doesn't ring or
.
Set the BASE UNIT RINGER switch to "La" or "HI".
receive a page.
The battery doesn't last as
.
Fully charge and discharge for three times.
long as it used to be.
.
Replace battery.