Table of Contents
Advertisement
P
DS815 Main Base
The original handset supplied with the Main Base is already registered as handset 1, this leaves handset numbers 2 - 7 available.
It is very important to allocate each handset a different number to enable functions such as Call Transfer.
Registration Process
Follow this process for each DS805 additional handset that needs to be registered to the Main Base.
1. Remove the handset from its charger
2. Press flash/reg on the handset (Fig 1).
3 Press the number 2 (Fig 2) for handset 2.
4. Place the handset in the Main Base Unit (Fig 4).
5. Press and hold the Registration button located on the back of the Main Base unit near the DC power jack
(Fig 4). Hold the Registration button in until a long beep confirms the handset has been registered.
Fig 4.
After Registration the handset number is
shown on the Display screen either during a
call or while the handset is charging (Fig 5).
(iii)
Registering your phone
This additional Handset is able to be used in conjunction with models DS815, DS825,
DS845 and DS875 cordless telephones.
The new handset needs to be allocated a handset number and registered to the Main
Base (DS815, DS825, DS845 & DS875). The Main Base has a telephone cord plugged
into it and also has an Antenna, not to be confused with the additional charger(s).
P
DS825 Main Base
REGISTER AS
HAND #2
Fig 1.
HANDSET: 1
NEW:
TOTAL:
Charging
P
DS845 Main Base
If you have additional handsets, repeat the same
process, but at Step 2 select a number from 3 - 7
to register the next handset as (fig 3)
REGISTER AS
HAND # (3 - 7)
Fig 2.
The Registration process needs to be completed within 15
seconds, 3 beep tones will indicate that the time has been
exceeded. Please start the process again.
TALK HIGH
1
1
On a Call
Fig 5.
If a handset is registered at any time as handset
1, all other handsets will need to be registered
again from Step 1.
O
DS805 Charger
Fig 3.
Handset
1
Registration
number
displayed
Advertisement
Table of Contents
