Troubleshooting - Uniden DS 805 Quick Start Manual

Optional handset and charge base
Table of Contents

Advertisement

18
QUICK REFERENCE CHART
If your phone is not performing to your expectations, please try these simple steps
first before calling Uniden customer service -
PROBLEM
No dial tone
No power on the
handset
Does not charge
Range is limited
Calls received,
flutter or fade
Cannot store or
recall phone
numbers from
memory
SUGGESTION
Check that the phone line cord connectors at both ends
are pushed in until they click.
If you have had a power failure or have unplugged the
base unit, replace the handset on the base unit for two
to five seconds to reset the system.
Check the handset has been registered (see page 11).
Check the battery pack plug, inside the battery
compartment of the handset, is fully pushed in.
The handset rechargeable Ni-Cad battery pack may need
to be charged.
Check the AC Adaptor is plugged in at both ends and
switched On.
Make sure the charging contacts on both the handset and
the base unit are in contact during charging.
The charging contacts may need to be cleaned with a dry
cloth or pencil eraser.
The battery pack may need to be discharged first before
a full charge can be accomplished.
Check the AC Adaptor is plugged in at both ends and
switched On.
Make sure the base antenna is vertical.
Move the base unit so that it is centrally located in your
residence or office and make sure that the base unit is
not located near electrical appliances.
The handset rechargeable battery pack may need
charging.
You may be out of normal operating range. Move closer
When storing phone numbers, make sure that the handset
is in the standby position.
When recalling stored numbers, check first for a dial
tone.

Advertisement

Table of Contents
loading

Table of Contents