Never use a stand that tilts the printer at an angle of more
than 15 degrees from horizontaL If you install a cut-sheet
feeder, the stand must keep your printer 1eveL
If you plan to load continuous paper through the bottom of
the printer, choose a stand that provides an unobstructed
Position your printeis power cord and interface cable so
they do not interfere with paper feeding. If possible, secure
the cables to a leg of the printer stand.
Align the paper stack so that the paper feeds straight into
the tract&s sprocket units.
Assembling the Printer
Removing the protective materials
During shipping, several pieces of packing material pro&t the
printer. Before you assemble the printer, you must remove
these protective materials as shown in the attached Notice
Note:
Installing the ribbon cartridge
Before instaIling the ribbon cartridge, make sufe that the
power cord is
1-4
Setting Up the Printer
not
plugged into an eIect&al outlet.