Tricity Bendix SG211X Instruction Book page 27

Replace the nozzles of the oven burners
Oven burner
To replace the gas oven nozzle, follow this
procedure:
Check the table no.1 for diameter of nozzle;
•
Remove the oven removable base panel;
•
Remove the screw 1 on the oven burner
•
Remove the oven burner by pulling it forwards.
•
Replace the nozzle by means of a No 7
•
socket spanner;
Reassemble the parts following the same
procedure in reverse.
Before fixing of the screw 1, ensure that the oven
burner is pushed correctly to the back panel.
Grill burner
To replace the gas grill nozzle, follow this procedure:
Remove the grill burner after removing the
•
fixing screws.
Replace the nozzle by means of a No 7
•
socket spanner;
Refit all parts and test.
•
Before fixing of the screws, ensure that the grill
burner is pushed correctly to the back panel.
Adjustment of minimum level
Oven burner
Light the burner knob on position
•
maximum and leave the oven door closed
for about 10 min.
Turn the knob slowly to position
•
minimum.
Pull off the knob to adjust minimum flow.
•
Unscrew or screw the by-pass screw (is it
•
above of tap shaft) until a regular small
flame is reached.
For LPG screw completely the by-pass
•
screw.
The flame shouldn't extinguish when closing
the oven door.
Grill burner
The grill temperature cannot be adjusted. To
obtain a lower temperature or slower cooking
time the grill pan must be lowered away from
the flame.
After completion of any repairs, conversion
or adjustments, the statutory safety tests
must be carried out.
by-pass
27