Choosing An Interface - Epson EX-1000 User Manual

Choosing an Interface

This section describes the interfaces.
IEEE-488 and Apple interfaces
The IEEE-488 system allows you to connect computers, printers, and
other peripherals so that they can share data freely Epson offers two -
types of IEEE438 interfaces. The #8161 offers the basic ability to
operate in the IEEE-488 address and listen-only modes. The #8165 has
the basic features and an 8K data buffer and a line monitor function,
which provides a diagnostic printout of IEEE-488 commands.
The Apple II, II + and IIe computers do not have a printer interface as
a standard feature. Epson produces a parallel interface board for the
Apple, which has software to control the functions of the printer. With
the #8131 interface installed in the Apple, no additional interface is
needed in the printer. An Apple IIc requires only a suitable cable for use
with the EX.
Buffered interfaces
If you often print very large amounts of text, a buffered interface can
free the computer for other tasks. Serial and parallel buffered interfaces
are available to increase the printer's data buffering capacity to either
32K or 128K (about 20 and 80 pages). See Table F-l.
The built-in serial interface on EX printers is suitable for almost all
applications. If, however, you need an interface that allows different
serial settings, such as word length or baud rate, or that conforms to the
Current Loop standard rather than RS-232C, you can install an optional
interface.
F-2
Choosing and Setting Up Optional Interfaces