Table of Contents
Advertisement
——————————————————————————————————————— Names of Machine Parts and Their Functions
Needle and presser foot
section
1
8
7
1 Buttonhole lever
Lower the buttonhole lever when sewing buttonholes
and bar tacks.
2 Thread guide discs
Pass the thread through the thread guide discs when
using the needle threader to thread the needle.
3 Needle bar thread hook
Pass the upper thread through the needle bar thread
hook.
4 Needle plate
The needle plate is marked with guides for sewing
straight seams.
5 Bobbin cover/shuttle
Remove the bobbin cover, and then insert the bobbin
into the shuttle.
6 Feed dogs
The feed dogs feed the fabric in the sewing direction.
7 Presser foot
The presser foot applies pressure consistently on the
fabric as the sewing takes place. Attach the appropriate
presser foot for the selected stitching.
8 Presser foot holder
The presser foot is installed onto the presser foot holder.
2
3
4
5
6
Right-side/rear view
3
4
5
6
1 Presser foot dial
Use the presser foot dial to adjust the amount of
pressure that the presser foot applies to the fabric.
2 Handle
Carry the sewing machine by its handle when
transporting the machine.
3 Balance wheel
Turn the balance wheel toward you to raise and lower
the needle to sew one stitch.
4 Air vent
The air vent allows the air surrounding the motor to be
exchanged. Do not cover the air vent while the sewing
machine is being used.
5 Main power switch
Use the main power switch to turn the sewing machine
on and off.
6 Foot controller jack
Insert the plug on the end of the foot controller cable
into the foot controller jack.
7 Power supply jack
Insert the plug on the power supply cord into the power
supply jack.
8 Feed dog position switch
Use the feed dog position switch to lower the feed dogs.
Memo
● Refer to Cover B, D or E pages while you
are learning to use your machine.
1
2
8
7
Cover C
Advertisement
Table of Contents
