Mixing Shaft Bearings; Wheel Bearings; Drum Shaft Bearing Hangers; Engine/Motor - Cleform Gilson 600MP Operator's Manual & Parts Manual

MIXING SHAFT BEARINGS

The mixing shaft bearings are permanently factory sealed and lubricated, and should not
require further service.

DRUM SHAFT BEARING HANGERS

Drum bearing hangers are located on each side of the drum, and are equipped with grease
fittings. These bearings should be lubricated once each week with lithium based grade 2
multi-purpose grease. SEE FIGURE 3

ENGINE/MOTOR

Refer to the engine/motor operating instructions for all maintenance and lubrication
instructions and requirements.

WHEEL BEARINGS

Wheel bearings should be packed once a year. Thoroughly clean old lubricant from the
bearings, hub and spindles before repacking. Pack bearings only one-half to two-thirds
full with grease to prevent overheating. Use no. 2 wheel bearing grease.
JACK SHAFT BEARINGS
Pillow block style bearing are used on the drive train counter-shaft. See Drum Seal
Housing, Lubrication Guidelines for more information. See Figure 4 for bearing
locations.
11