Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Cleform 600CM
Summary of Contents for Cleform 600CM
- Page 1 GILSJ J N MIXERS CONCRETE MIXER MODEL 600CM OPERATING INSTRUCTIONS & PARTS LIST GILSJ J N MIXERS 4343 Easton Road · St. Joseph, MO 64503 816-233-4840 · 800-253-3676 Fax 816-233-4624 · 888-253-3676 E-Mail: cleform@ccp.com Web Address: www.cleform.com...
- Page 2 TO THE OWNER: This owner’s manual provides the information needed to operate and maintain this Gilson mixer. Carefully read and follow all safety and operating instructions in this manual. Also, be sure every operator of this mixer reads this manual before operating the mixer.
- Page 3 Table of Contents 1. Warranty Information 2. Safety Instructions, Pre-operational Checks 3. Lubrication 4. Care of Mixer 5. Batch/Mix Instructions 6. Parts Explosions and Lists HOW TO OBTAIN PARTS AND SERVICE INFORMATION For parts and service information,contact either your local dealer or the Cleform Tool Corp. factory: CLEFORM TOOL CORP.
-
Page 4: Exclusions From Warranty
30 days after the expiration of the warranty period. EXCLUSIONS FROM WARRANTY: 1. The following items are not covered under the GILSON MIXER One Year Limited Warranty and are warranted by the respective manufacturer: Engines, including starters, generators, alternators and gear reducers. -
Page 5: Safety Instructions
SAFETY INSTRUCTIONS SAFETY PRECAUTIONS: This is the industry’s safety alert symbol. This symbol calls attention to items or operations that could be dangerous. This symbol can be found throughout this manual and on safety decals on the mixer. Read these messages carefully. The following precautions are suggested to help prevent accidents. -
Page 6: Prior To Start-Up
TOWING & SAFETY CHAINS: For transporting the mixer, slide the tow pole out as far as possible and insert the locking pin. When operating the mixer, slide the tow pole in and lock it in place. Make sure drum is locked in position and engine housing is closed and secured. Cross the safety chains under the tow pole and fasten them to the tow vehicle. -
Page 7: Mixing Instructions
Drum Tilt Brake Bearing: The brake bearing casting is located near the front of the mixer and should be greased weekly. Handwheel Bearing: The handwheel hub bearing is located on the front of the mixer, behind the handwheel. This bearing should be greased weekly. WARNING: DO NOT GREASE BRAKE BAND OR OUTER BRAKING SURFACE OF TILT GEAR.