Advertisement
You can program
tile supplied
remote conm_ander
to
operate
a cable box or DBS receiver.
Follow the
procedures
below to set the manufacturer's
code number
in the remote commander.
DISPLAY*
CODE SET
,.,,,Q ® ® ®
_ DBS/CABLE
(POWER)
_'_.DBS/CABLE
(FUNCTION)
0 - 9 buttons
_ENTER
_GUIDE*
'-_ ",1_'1.1"_1 _
*
_-_MENU*
_CH +/-
* The TV/DBS,
GUIDE,
DISPLAY,
._/._/._./.o./_
and MENU
buttons
can be used
only with
a DBS receiver.
1
2
Turn off the equipment
you want
to set up,
and press DBSICABLE (FUNCTION).
FUNCTION -
-
DBS/CABLE
Press the CODE SET, DBS/CABLE (FUNCTION),
and 0 - 9 buttons
to enter the
manufacturer's
code number
(see the chart),
then press ENTER. For example,
to program
your remote
commander
to operate
a Sony
DBS receiver,
press CODE SET, DBS/CABLE
(FUNCTION),
8, 0, 1, and ENTER.
FUNCTION
ENTER
3
Press DBS/CABLE (POWER) to turn on the
cable box or DBS receiver.
POWER
DBS/CABLE
4
Use the cable box/DBS control
buttons
to
check if the code number
works.
For example,
to operate
a cable box or DBS receiver,
you can use the DBS/CABLE
(POWER), JUMP, CH
+/-, 0 - 9 and ENTER buttons.
Note
• If the cable box or DBS receiver
does not have a certain
function,
the corresponding
button
on this remote
commander
will not operate.
To operate
the projection
TV
Press TV (FUNCTION).
Then use the projection
TV
control buttons
to control
the projection
TV.
For more details
on operating
the cable box or
DBS receiver
Refer to the operating
instructions
that come with the
equipment.
If the
remote
commander
doesn't
work
• First, try repeating
the setup
procedures
using
the other
codes
listed for your equipment.
Manufacturer
code numbers
(cable box)
Manufacturer
Code
number
Hamlin/Regal
222, 223, 224, 225, 226
Jerrold/G.
I.
201,202,
203, 204, 205, 206, 207, 208,
218
Oak
227, 228, 229
Panasonic
219, 220, 221
Pioneer
214, 215
Scientific
Atlanta
209, 210, 211
Tocom
216, 217
Zenith
212, 213
Manufacturer
code numbers
(DBS receiver)
Manufacturer
Code
number
Sony
801 (preset code for the supplied
remote
commander)
RCA
802
Notes
• If more than one code number
is listed,
try entering
them one by
one until you come to the correct
code for your equipment.
• If you enter
a new code number,
the code number
you
previously
entered
at that setting
is erased.
• In some rare cases,
your equipment
may use a code that is not
provided
with
this remote
commander
and you may not be able
to operate
your equipment
with
the supplied
remote
commander.
In this case, use the equipment's
own remote
control
unit.
* Whenever
you remove
the batteries
-- to replace
them, for
example
-- if too much
time is taken,
the code numbers
may
revert
to the factory
setting
and must be reset.
Operations
I 39-EN
Advertisement
