Sony Handycam DCR-DVD608 Operating Manual page 105

Moisturecondensation
If your camcorder is brought directly from a
cold place to a warm place, moisture may
condense inside your camcorder, on the
surface of the disc. or on the pickup lens.
This may cause a malfunction to your
canlcorder.
N l! moisture condensationhas occurred
Leave your catncorder for about 1 hour
without tuming it on.
N Note on moisture condensation
Moisture may condense when you bring
your camcorder from a cold place into a
warm place (or
vice versa)
or when you use
your camcorder in a humid place as
follows:
• You bring your camcorder from a ski
slope into a place warmed up by a heating
device.
• You bring your camcorder from an air
conditioned car or room into a hot place
outside.
• You use your camcorder after a squall or a
shower.
• You use your camcorder ill a hot and
humid place.
N How to prevent moisturecondensation
When you bring your camcorder from a
cold place into a warm place, put your
camcorder in a plastic bag and seal it
tightly. Remove tile bag when tile air
temperature inside the plastic bag has
reached tile surrounding temperature (after
about 1 hour).
LCDscreen
• Do not exert excessive pressure on the LCD
screen, as il may
c_luse damage.
• If your camcorder is used in a cold place, a
residual image may appear on the LCD scrcen.
This is not a malflmction.
• While using your camcorder, the back of the
LCD SClX3en may heal lip. Tiffs is not a
mallhnction.
N To clean the LCD screen
If fingerprints or dust make the LCD screen
dirty, it is recommended you use a soft
cloth to clean it. When you use the LCD
Cleaning Kit (optional), do not apply the
cleaning liquid directly to the LCD screen.
Use cleaning paper moistened with tile
liquid.
@ On adjustmentof the touch panel
(CALIBRATION)
The buttons on tile touch p:ulel may not
work correctly. If this happens, follow tile
procedure below. It is recommended that
you connect your camcorder to the wall
outlet using the supplied AC Adaptor
during the operation.
(!) Turn on your camcorder, then press
_(HOME).
@ Touch _ (SETTINGS) ---+ [GENERAL
SET] ---+ [CALIBRATION].
@ Touch "x" displayed on the screen with the
corner of the "Memory Stick Duo" or the
like. The position of "x" changes.
Touch [CANCEL] to cancel.
If you did not press tile right sput, try the
calibration again.
0 Notes
• Do not use a sharp-lx)inted object lor
calibration. Doing so may damage tile LCD
screen.
• You cannot calibrate llle LCD screen if it is
rolated, or closed wilh lhe sclvml li_cing out.
g
m
=Z
3
g
Continued._
105