Sony Handycam DCR-SX83 Operating Manual page 271

•The f ollowing states will be indicated ifdata isstill being written onto the r ecording media after recording
has finished. During this t ime, do not apply shock or vibration to the c amcorder, or remove the b attery or
AC Adaptor.
-Access lamp (p. 20) is litor flashing
-The m edia icon inthe u pper right ofthe L CD s creen is flashing
OTips
• 5_u can record photos during movie recording by pressing PHOTO fully (Dual Rec).
• When a fhce is detected, a white fl'ame appears and the image quality around the fhce is optimized
automatically ([FACE DETECTION]).
• 5_u can specify the priority lhce by touching it.
• In the defimlt setting, a photo is recorded automatically when the camcorder detects the smile of a person
during movie recording.
• You can capture photos fi'om recorded movies.
• See page 59 on the recordable time of movies.
• 5_u can check tlre recordable time, estimated remaining capacity, etc., by touching _ (MENU)
[Show others[ _ [MEDIA INFO] (under _i,) [MANAGE MEDIA] category).
• The LCD screen of your camcorder can display recording images across the entire screen (full pixel
display). However, this may cause slight trimming of the top, bottom, right and left edges of images when
played back on a TV which is not compatible with full pixel display. In this case, set [GUIDEFRAME] to
[ON], and record images using the outer fl'ame displayed on the screen as a guide.
• [gZ_STEADYSHOT] is set to [ACTIVE] in the defimlt setting.
• To adjust the angle of the LCD panel, first open the LCD panel 90 degrees to the camcorder (@), and
then adjust the angle (@).
@ 90 degrees (max.) ff(_
(g) 180 degrees (max.) -- (!) 90 degrees to
the camcorder
Data code during recording
The recording date, time and condition are recorded automatically on the recording media.
They are not displayed during recording. Howew, r, you can check them as [DATA CODE]
during playback. To display them, touch _ (MENU) ---+ [Show others] ---+ [PLAYBACK
SET] (under {_ [PLAYBACK] category) ---+ a desired setting ---+ _ ---+ _ ---+l$'?l
g
3
_3