Troubleshooting - Sony Handycam HDR-PJ710V Operating Manual

Others/Index
Troubleshooting
If you run into aW problems using your
camcoMer, fbllow the steps below.
(Z) Check the list (p. 74 to 76), and
inspect your camcorder.
@ Disconnect the power source, attach
the power source again after about 1
minute,
and turn the camcorder on.
@ Press RESET(p. 14) using a pointed
object,
and turn the camcorder
on. If you press RESET, all settings,
including the clock setting, are reset.
(_) Contact your Sony dealer or local
authorized Sony service facility.
• _ur camcorder may be required to initialize
or change the current internal memory of your
camcorder, depending on the problem. In the
event of this, the data stored on the internal
memory will be deleted. Be sure to save the
data on the internal memory on other media
(backup) bdbre sending your camcorder fbr
repair. We will not compensate you fbr any loss
of internal memory data.
• During repair, we may check a mininmm
amount of data stored on the internal memory
in order to investigate the problem. However,
your Sony dealer will neither copy nor retain
your data.
• See the "Handycam" User Guide (p. 9) lbr
details on the symptoms of your camcorder, and
"PlayMemories Home Help Guide" (p. 60) on
connecting your camcorder to a computer.
The power does not turn on.
• Attach a charged battery pack to the
camcorder (p. 18).
• The plug of the AC Adaptor has been
disconnected fi'om the wall outlet (wall
socket). Connect it to the wall outlet (wall
socket) (p. 20).
The camcorder does not operate even
when the power is set to on.
• It takes a few seconds tor your calncorder to
be ready to shoot at}er the power is turned on.
This is not a maltunction.
• Disconnect the AC Adaptor ti'om the wall
outlet (wall socket) or remove the battery
pack, then reconnect it atier about 1 minute.
If the functions still do not work, press RESET
using a pointed object. (If you press RESET
(p. 14), all settings, including the clock setting,
are reset.)
• The temperature of your camcorder is
extremely high. Turn off your camcorder and
leave it for a while in a cool place.
• The temperature of your camcorder is
extremely lo_< Leave your camcorder with the
power of your camcorder on. Turn off your
camcorder and take it to a warm place. Leave
the camcorder there for a while, then turn on
your camcorder.
Your camcorder gets warm.
• Your camcorder may become warm during
operation. This is not a malfunction.
The power abruptly turns off.
• Use the AC Adaptor (p. 20).
• In the defimlt setting, when about 2 minutes
have elapsed while you do not operate your
camcorder, the camcorder automatically turns
off. Change the setting of [Eco Mode] (p. 73),
or turn on the power again.
• Charge the battery pack (p. 18).
Pressing START/STOP or PHOTO does not
record images.
• The playback screen is displayed. Press MODE
to turn on the _ (Movie) or I1_ (Photo) lamp
(p. 27).
• Your calncorder is recording the image you
have just shot on the recording media. "*2m
cannot make new recording during this
period.