Troubleshooting - Sony CDX-L410X Operating Instructions Manual

Troubleshooting
The lbllowing checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check
the connection and operating procedures.
No sound.
• Press the volume + button to adjust the
volume.
• Cancel the ATT function.
• Set the fader control to the center position lbr
a 2-speaker system.
The contents of the memory have been
erased.
• The RESET button has been pressed.
-+ Store again into the memory.
• The power cord or battery has been
disconnected.
• The power connecting cord is not connected
properly.
No beep sound.
• The beep sound is canceled (page 12).
• An optional power amplifier is connected
and you are not using the built-in amplifier.
The display disappear from/does not appear
in the display window.
• The display disappears if you press and hold
Press and hold _ again until the
disappears.
• Remove the t?ont panel and clem_ the
connectors. See "(-'leaning the connectors"
(page 13) for details.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the ignition key is in the
ON, ACC, or OFF position.
The leads are not matched correctly witl_ the
car's accessory power connector.
No power is being supplied to the unit.
• Check the connection, if everything is in
order, check the fuse.
• The ear does not have an ACC position.
--* Press _ (or insert a disc) to turn
on the unit.
The power is continuously supplied to the
unit.
The car does not have an ACC position.
The power antenna does not extend.
The power antenna does not have a relay box.
A disc cannot be loaded.
• Another CD is already loaded.
• The CD has been lbrcibly inserted upside
down or in the wrong way.
Playback does not begin.
• Defective dirty CD.
• CD-R/CD-RW that is not finalized.
• You tried to playback a CD-PUCD-RW not
designed tbr audio use.
• Some CD-Rs/CD-RWs may not play due to
its recording equipment or the disc
condition.
A disc is automatically ejected.
The ambient temperature exceeds 50°C
(122°F').
The operation buttons do not function.
CD will not be ejected.
Press the RESET button.
The sound skips from vibration.
• The unit is installed at an angle of more thas_
60 ° .
• The unit is not installed in a sturdy part of
the car.
The sound skips.
Dirty or defective disc.
16