Table of Contents
Advertisement
Insome a reas it willbenecessa
O, t ouse anoutd _ antenna.
The VHF/UHF
Rod Amenna (.supplied) is detachable.
Insert the stem of the antenna into the hole on the
upper-back
portion of the TV/VCR.
Connect
the VHF/UHF
Rod Antenna
or VHF/Ut4F
Combination
Antenna
to the ANT. terminal
hi the
TV/VCR as shown in the diagram below.
For the best reception, fully extend the VHF/UHF
Rod
Antenna
and make the necessary, adjustments.
(Avoid
touching the top section when adjusting.)
NOTE:
Belore plugging the Rod antenna into antenna terminal,
check that the pin is not bent. If it is bent, straighten the
pin as illustrated, then plug the pin into antenna terminal.
Bent pin
CabLe
Plug
(Needs to be straightened)
(Straight
pin)
Rod Antenna
(Supplied)
1
VHF/UHF Antenna
(Not supplied)
[Fig.4]
NOTE:
The connection
of an indoor antenna may not always
give acceptable
TV reception.
VHF Antenna (Not supplied)
_Antenna
(Not supplied)!
VHF/UHF
_
_
[
(Not biner
_
supplied)
._ J
Flat twin-lead cable [Fig.5]
Use this connection
if your cable system connects
directly to your TV/VCR without a converter box.
By using this connection
you can:
1) Use the TV/VCR remote to select channels
2) Program
one or more unscrambled
channels
for
Automatic Timer Recording.
NOTE:
This unit will ONLY record and view the same
:hannel.
From Cable System
75-ohm Coaxial
Cable (Not
supplied)
1
ANT.
[Fig.6]
I Note to CATV system installer:
This reminder
is provided to call the CATV system installer's
attention
to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular, specifics that the cable ground shall be connected
to the grounding system of the building as close to the point of cable entry as practical.
Antenna/Cable
Connections
Continued
on the Next Page.
- I0 -
EN
9A07
Advertisement
Table of Contents
