Arrival Times - TomTom GO Manual

To change this setting, do the following:
1. Tap Start-up preferences in the Preferences menu and then select Ask for
a destination.
2. Tap Yes, then tap Yes again to begin entering information about the desti-
nation.
3. Select a symbol for the destination and tap Done to set the symbol, then tap
Yes.
Tip: If you want to choose a title of your own, select a numbered symbol.
4. Tap Yes and if required enter a new name, then tap Done.
5. Enter the address details in the same way you enter an address when plan-
ning a route, then tap Done.
6. If you want to set more destinations, repeat the steps above. Otherwise, tap
Done.
You are asked if you want to change the start-up image.
7. If you want to change the image, follow the instructions shown on the
screen. Otherwise, tap No.
Every time your TomTom GO starts, you are asked if you want to plan a route.
If you tap Cancel, you are shown the Main Menu.

Arrival times

When you plan a route, your TomTom GO asks you if you need to arrive at a
particular time.
Tap YES to enter a preferred arrival time.
Your GO calculates your arrival time and shows you whether you will arrive
on time.
You can also use this information to work out when you need to leave. If your
GO shows that you will arrive 30 minutes early, you can wait and leave in 30
minutes time, rather than arrive early.
Your arrival time is constantly recalculated during your journey. The status bar
shows whether you will arrive on time or if you are going to be late, as shown
below:
You will arrive 55 minutes before the arrival time you entered.
If the estimated arrival time is more than five minutes before
the time you entered, it is shown in green.
You will arrive 3 minutes before the arrival time you entered.
If the estimated arrival time is less than 5 minutes before the
time you entered, it is shown in yellow.
You will arrive 19 minutes late.
If the estimated arrival time is later than the time you entered,
it is shown in red.
9