Before You Start - TomTom Blue&Me Manual

2.

Before you start

Before you start
Type of Dock
Your product includes either the Dash Dock or the Active Dock. Use the
images above to see which Dock is included in your product. Follow the
instructions below to install your Dock in your car. Alternatively, follow the vis-
ual instructions at the start of this guide.
Installing the Dash Dock (A)
Use the dash dock to install your Blue&Me-TomTom navigation device inside
the car.
To attach the dash dock, insert the base of the dock into the dash plug on the
car dashboard.
To insert your navigation device into the dock, push the button on the front of
the dock to open the top bracket. Place the bottom of the device into the dock
and then push the top bracket of the dock down until it clicks into place. Rotate
your device to a position that suits you best.
To remove the navigation device, press the button on the front of the dock and
lift the navigation device out.
To release the dock from the dashboard, push the lower button on each side
of the shaft and pull out the dock.
Installing the Active Dock (B)
Make sure that both the Active Dock and your window are clean and dry.
1. Press the suction cup firmly against the window on an area where the glass
is flat.
2. Twist the rubber grip near the base of the Active Dock in a clockwise direc-
tion until you hear a click.
The Active Dock is now installed.
Positioning the Active Dock
Consider carefully where to attach the dock in your car. The dock should not
block or interfere with any of the following:
• Your view of the road
• Any of the controls in your car
• Any of your mirrors
• The airbag
When your navigation device is in the dock, you should be able to reach the
device easily without leaning or stretching. The diagrams show where you can
safely attach the dock.
3