Table of Contents
Advertisement
VlZlO VA370M User Manual
Remote
Control
Range
•
The effective range of the remote control is approximately 30 feet (10 meters) from the front of
the receiver window and 13 feet (4 meters) when 30 ° to the left and right, 20 ° up and down.
•
Point the remote control at the remote control sensor on the front of your HDTV to send
commands.
•
Do not place any obstacles between the remote control and the remote control sensor.
•
Keep the remote dry and away from heat sources and humidity.
•
If your HDTV responds erratically to the remote control or does not respond at all, check the
batteries. If the batteries are low or exhausted, replace them with fresh batteries.
•
When not using the remote control for a long period of time, remove the batteries.
•
Do not take the batteries apart, heat them, or throw them into a fire.
•
Do not subject the remote control to undue physical stress, such as striking or dropping it.
•
Do not attempt to clean the remote control with a volatile solvent. Wipe it with a clean, damp
cloth.
•
Do not mix old and new batteries or different types of batteries.
Mns÷rtin
9 the
r÷mot÷
control
batteries
1.
Remove the battery cover on the back of the remote control.
2.
Insert two AA batteries (included) into the remote control, making sure you match the (+) and (-)
symbols on the batteries with the (+) and (-) symbols inside the battery compartment.
3.
Re-attach the battery compartment
cover.
Precautionary Tips for Inserting the Batteries:
•
Only use the specified AA batteries.
•
Do not mix new and old batteries. This may result in cracking or leakage that may pose a fire
risk or lead to personal injury.
•
Inserting the batteries incorrectly may also result in cracking or leakage that may pose a fire
risk or lead to personal injury.
•
Dispose of the batteries in accordance with local laws and regulations.
•
Keep the batteries away from children and pets.
U )ng
a ¢ab(e
or
Sate(()te
)clot÷
Your VlZlO remote uses codes 11758 and 10178 to work your LCD HDTV. To use a cable or satellite remote
to work the LCD HDTV, refer to your cable or satellite remote user guide for more information on how to
program the remote.
If your cable or satellite remote uses a 5-digit code (like most Direct TV units), first try
11758 and then, if that does not work, 10178. If your cable or satellite remote uses a 4-digit code, try 1758 and
then 0178 as an alternative. If your cable or satellite remote uses a 3-digit code (EchoStar or Dish Network for
example), use code 627.
I,
2.
Use a soft cloth for cleaning.
If the housing or remote control is seriously contaminated,
use a soft cloth moistened with
diluted neutral cleaner to clean the display.
Wring water out of the cloth before cleaning to
prevent water from penetrating into the housing.
Wipe the display with a dry cloth after
cleaning.
Version 7/23/2009
15
www.VlZlO.com
Advertisement
Table of Contents
