Epson C2600/2600 Owner's Manual page 248

Item
GL Mode
Scale
Origin
Pen
End
Join
Pen 0 through 6
* Available only when GLlike is selected as the GL Mode.
Before you start printing in the GL/2 mode
You may need to change the following print options in your
application, depending on your output needs. Check these
settings to make sure they match the data you are trying to print.
Print Options
Paper size
Driver (plotter
selection)
Pen configuration
Plot origin
Orientation
If you need to configure the printer settings, first switch to the
GL/2 emulation mode, then change the settings using the printer
driver, or the control panel menus.
248
Using the Control Panel
Settings (default in bold)
LJ4GL2, GLlike
Off, A0, A1, A2, A3
Corner, Center
Pen0, Pen1, Pen2*, Pen3*, Pen4*, Pen5*,
Pen6*
Butt, Square, Triangular, Round
Mitered, Miteredbeveled, Triangular,
Round, Beveled, None
0.05 ... 0.35 ... 5.00 mm in 0.05-mm
increments
Settings
Printer's paper size setting
HP-GL/2 or HP-GL
Pen thickness
Center or Corner
GLlike offers landscape only LJ4GL2 offers
landscape and portrait