Safety Information - Epson AcuLaser C8600 Setup Manual

Unplug the printer and contact a qualified service
representative under the following conditions:
A. If liquid has entered the printer
B. If the printer has been exposed to rain or water
C. If the printer does not operate normally or exhibits a
distinct change in performance
D. If the printer has been dropped or the cabinet damaged
E. If the power cord or plug is damaged or frayed
Adjust only those controls that are covered by the operating
instructions. Improper adjustment of other controls may
result in damage that requires repair by a qualified service
representative.
If you plan to use the printer in Germany, observe the
following:
To provide adequate short-circuit protection and
over-current protection for this printer, the building
installation must be protected by a 10 or 16 amp circuit
breaker.

Safety Information

Power cord
Caution:
c
Be sure the AC power cord meets the relevant local safety
standards.
Safety Instructions
5