Weslo PURSUIT S 2.8 User Manual page 8

6. 6
Attach the Handlebar (49) to the Upright (13)
with two M8 x 65mm Button Bolts (50), two M8
Split Washers (42), and two M8 Locknuts (10).
42
7. The Console (16) requires four AA batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the Console has been
exposed to cold temperatures, allow it to
warm to room temperature before inserting
batteries. Otherwise, you may damage the
console displays or other electronic compo-
nents. Remove the battery cover, insert the
batteries into the battery compartment, and
reattach the battery cover. Make sure to orient
the batteries as shown by the diagram
inside the battery compartment.
Screw---- 1 Battery
_;,j_Cover
16
i
Batteries
8.
While a second person holds the Console (16)
near the Upright (13), connect the console wire
to the Extension Wire (23). Then, insert the
wires downward into the Upright.
Tip: Do not pinch the wires. Attach the
Console (16) to the Upright (13) with four M4 x
16ram Screws (46).
8
46
16
Wire
--13 Do not pinch
the wires
during this step
8