Weslo PURSUIT S 2.8 User Manual page 12

When you turn Indicators
on the power, the
scan mode will
be selected auto-
matically. One
indicator will
appear below the
word Scan to RPMSPEEDTIME DISTANCE
show that the
scan mode is
selected, and a second indicator will show which
information is currently displayed. Note: If you
have selected a different mode, press the Display
button repeatedly to reselect the Scan mode.
To select the
speed, time, dis-
tance, or calories
mode for continu-
ous display,
press the Display
button repeated-
ly. Indicators will
show which
SCAN PULSE CALORIES
RPM SPEED TIME DISTANCE
mode is selected. Make sure that there is not an
indicator below the word Scan.
Note: The con-
sole can show SCAN PULSECALORIES
speed and dis- _"
tance in either
miles or kilome-
ters. The letters
RPM SPEED TiME DISTANCE
"mph" or "km/h"
will appear in the
display to show which unit of measurement is
selected. To change the unit of measurement, first
hold down the On/Reset button for a few seconds.
An "E" (for English) or an "M" (for metric) will
appear in the display. Press the Display button to
change the unit of measurement. Note: When the
batteries are replaced, it may be necessary to
reselect the desired unit of measurement.
To reset the display, press the On/Reset button.
To pause the console, stop pedaling. If the time is
displayed, it will flash. To continue your workout,
simply resume pedaling.
3. Measure your heart rate if desired.
4.
To measure your
heart rate, stop
pedaling and
place your thumb
on the pulse sen-
sor. Do not press
too hard, or the
circulation in
SCAN PULSE CALORIES
;35"
RPM SPEED TIME DISTANCE
your thumb will be restricted and your pulse
will not be detected. After a few seconds, the
heart-shaped indicator in the display will flash
steadily, two dashes will appear, and then your
heart rate will be shown. Hold your thumb on the
pulse sensor for about 15 seconds for the most
accurate reading.
If the displayed heart rate appears to be too high or
too low, or if your heart rate is not displayed, lift
your thumb off the pulse sensor for a few seconds.
Then, place your thumb on the pulse sensor as
described above.
Make sure you are applying the proper amount of
pressure to the pulse sensor. Try the pulse sensor
several times until you become familiar with it.
Remember to stand still while measuring your
heart rate.
When you are finished exercising, the console
will turn off automatically.
If the pedals do not move for a few seconds, the
console will pause. If the pedals do not move for a
few minutes, the console will turn off and the dis-
play will be reset.
12