M5 X 16Mm Screw (85) - Weslo CROSSWALK 5.2T User Manual

,
Set the Right Handrail (33) on the console
assembly. Make sure that the console wire is
not pinched. Remove the tie from the bracket
on the Right Handrail. If necessary, press the
Cage Nut (102) back into place.
Start an M5 x 16mm Screw (85) with an M5
Star Washer (7) into the Right Handrail, and
then start two M4.2 x 19mm Screws (10) into
the Right Handrail. Tighten the M5 x 16ram
Screw and then tighten the two M4.2 x 19ram
Screws; do not overtighten the Screws.
Attach the Left Handrail (not shown) to the
console assembly in the same way. Note:
There is no wire on the left side.
4
Console
Assembl,
Console Wire
102
Tie
33
10
,
With the help of a second person, hold the con-
sole assembly near the Right Upright (54).
Connect the Wire Harness (39) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. If there is a wire tie on the Wire
Harness, remove the wire tie. Insert the con-
nectors and the excess wire downward into the
Right Upright (54).
Console
Wire
Console
Y
Console
Wire
\
39
9