Weslo Crosswalk 5.0t User Manual page 8

.
Set the Right Handrail (33) on the console as-
sembly. Make sure that the console wire is
not pinched. Remove the tie from the bracket
on the Right Handrail. If necessary, press the
Cage Nut (110) back into place.
Start an M5 x 16mm Screw (85) with an M5 Star
Washer (7) into the Right Handrail (33), and
then start two M4.2 x 19mm Screws (10) into
the Right Handrail. Tighten the M5 x 16ram
Screw and then tighten the two M4.2 x 19ram
Screws; do not overtighten the Screws.
Attach the Left Handrail (not shown) to the
console assembly in the same way. Note:
There is no wire on the left side.
Console
110
ar_
Console
Assembly
7
33
10
%
.
With the help of a second person, hold the con-
sole assembly near the Right Upright (54).
Connect the Wire Harness (39) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. If there is a wire tie on the Wire
Harness, remove the wire tie. Insert the connec-
tors and the excess wire downward into the
Right Upright (54).
39
Console
Wire
Console
Assembly
Console
Wire
.
Set the console assembly on the Uprights (53,
54). Make sure that no wires are pinched.
Start four M8 x 15mm Bolts (8) with four M8 Star
Washers (5) into the Uprights as shown. Do not
tighten the Bolts yet.
Console Assembly