Product Dimensions And Clearances; The Installation Space - GE ZFSB23D SS Installation Instructions Manual

Free-standing side-by-side stainless steel refrigerator
Table of Contents

Advertisement

PRODUCT DIMENSIONS
AND CLEARANCES
36"
29-1/2"
Including
Handles
This Monogram free-standing refrigerator requires
the following clearances for proper air circulation,
plumbing and electrical connections.
Air Circulation Clearances:
• 1/8" on each side
• 1" at the top
• 1" at the back
Installation in a corner:
• Allow 4" clearance on each side to an adjacent wall
for a 90° opening and access to drawers.
14-1/4"
160° Door Swing
• On the freezer side, allow 14-1/4" min. clearance
for removal of ice bin.
• On the fresh food side, allow 19" min. clearance
to wall for removal of drawers.
Planning Information
27-1/2"
Case
Depth
72"
19"
90° Door Swing

THE INSTALLATION SPACE

The opening width must be 36-1/2".
73" min.
Water And Electrical Locations
The opening must be prepared with the electrical and
water supply located as shown.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install a
properly grounded 3-prong electrical receptacle
recessed into the back wall.
Note: GFI (ground fault interrupter) is not recom-
mended.
• Water line can enter the opening through the floor
or through an adjacent cabinet, as close to the back
wall as possible. The water line should be 1/4" O.D.
copper tubing between the cold water line and
water connection location at the rear of the refrig-
erator. Installation of an easily accessible shut off
valve in the water line is recommended.
24"
22"
3
36-1/2"
Wall View
Electrical
Area
Water Supply

Advertisement

Table of Contents
loading

Table of Contents