Connecting A Cable; Setup Flow; Setup For Windows - Oki 4600 User Manual

B4400
To print Network Information:
1. Turn the printer ON.
2. Press and hold the TEST button on the print server
located on the back of the printer for 5 seconds.
3. The Network Information sheets print.

Connecting a Cable

1. Turn off the printer and Computer.
2. Insert an Ethernet cable into the network interface
connector on the printer.
3. Insert the Ethernet cable into a hub.

Setup Flow

Turn ON the printer and computer.
Set the IP address, etc. in Windows.
Set the IP Address, etc. in the printer.
Install the printer driver and OKI LPR Utilities from
the Printer Software CD-ROM supplied with the
printer.

Setup for Windows

NOTE: The following setup instructions are for Windows XP/
2000/Server 2003. The setup procedure for Windows ME/98/
NT4.0 are similar.
An IP address must be set in the computer and the printer
when the printer is used on a network. If there is no DHCP,
⇓
⇓
⇓
B4400/4500/4600 User's Guide
48