HP rp7400 Installation Manual page 9

9. Locate and remove one of the four screws from the plastic pouch. Attach the a caster to the server.
Figure 1-5 Attaching a Caster to the Server
10. Attach the remaining casters to the server using screws supplied in the plastic pouch.
11. Remove the foam blocks from the left and right side of the server.
12. Locate the plywood ramp.
13. Attach the ramp to the edge of the pallet.
NOTE There are two pre-drilled holes in the ramp. Use the two screws taped to the ramp to attach
the ramp to the pallet.
14. Carefully roll the server off the pallet and down the ramp.
15. Locate the caster covers.
Chapter 1
Wheel Kit Installation Guide
Wheel Kit Installation
MWK005
3/12/03
9